EVS IPDirector Version 5.6 - May 2009 Part 7 User's Manual User Manual

Page 172

IPDirector V.5.6 – User Manual – Part 7: Editing - IPEdit

EVS Broadcast Equipment – May 2009

Issue 5.6.A

163

4. Do one of the following to define a swap or mute:

•

For a swap, click in the matrix at the intersection between the source
channel to play and the output channel on which the source should be

played.

•

For a mute, click in the matrix on the bullet located on the line of the

output channel to mute.

5. If you want to apply the swap between a mark IN and mark OUT points, tick

the Apply between mark IN and mark OUT check box.

In this case, you can overwrite existing swap/mute between these points by
ticking the Overwrite existing swap/mute check box.

6. If you want to define a mix effect at the start and end of the swap, specify the

duration of the effect in the Swap mix duration spin box.

7. Click Apply.

The swap and mutes are defined on the requested part of the audio track.

This is symbolized with the swap icon

or the mute icon

displayed on the

relevant elements in the general display of the timeline.

The swaps and mutes can be viewed on the Swap/Mute Zoom display: