EVS IPDirector Version 5.6 - May 2009 Part 7 User's Manual - Manual (Page 171)

Issue 5.6.A IPDirector V.5.6 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment - 2009
162
H
OW TO
A
DD A
S
WAP OR
M
UTE
F
ROM AND TO
G
IVEN
P
OINTS
OF A
T
RACK
To add an audio swap or mute from and to given points of an audio track, proceed
as follows:
1.
In the general timeline display, click the Swap/Mute Zoom icon on the
right of the track on which to add the swap or mute.
The track is displayed in Swap/Mute Zoom mode.
2. Do one of the following to specify the start and end point of the swap:
• Place a mark IN at the start point and a mark OUT at the end point.
• Place the nowline at the start point if you want the end point to be the end
of the element.
3. Right-click after the nowline or between the mark IN and mark OUT points
and select Add Swap/Mute.
The Swap/Mute Configuration window opens: