Texas Instruments TMS320C2XX - Manual (Page 526)

Physical Dimensions for the 14-Pin Emulator Connector
E-14
E.7 Physical Dimensions for the 14-Pin Emulator Connector
The JTAG emulator target cable consists of a 3-foot section of jacketed cable
that connects to the emulator, an active cable pod, and a short section of jack-
eted cable that connects to the target system. The overall cable length is
approximately 3 feet 10 inches. Figure E–8 and Figure E–9 (page E-15) show
the physical dimensions for the target cable pod and short cable. The cable
pod box is nonconductive plastic with four recessed metal screws.
Figure E–8. Pod/Connector Dimensions
0.90 in.,
nominal
2.70 in., nominal
4.50 in., nominal
9.50 in., nominal
See Figure E–9
Emulator cable pod
Short, jacketed cable
Connector
Note: All dimensions are in inches and are nominal dimensions, unless otherwise specified. Pin-to-pin spacing on the connec-
tor is 0.100 inches in both the X and Y planes.