SMC Networks TigerAccess SMC7816M - Manual (Page 560)

U
SER
A
UTHENTICATION
C
OMMANDS
22-20
Telnet Server Commands
This section describes commands used to configure Telnet management
access to the switch.
ip telnet server
This command allows this device to be monitored or configured from
Telnet. It also specifies the TCP port number used by the Telnet interface.
Use the no form without the “port” keyword to disable this function. Use
the no from with the “port” keyword to use the default port.
Syntax
ip telnet server [port port-number]
no telnet server [port]
• port - The TCP port used by the Telnet interface.
• port-number - The TCP port number to be used by the browser
interface. (Range: 1-65535)
Default Setting
Server: Enabled
Server Port: 23
Command Mode
Global Configuration
Example
Table 22-9 Telnet Server Commands
Command Function Mode Page
ip telnet server Allows the switch to be monitored or
configured from Telnet; also specifies the
port to be used by the Telnet interface GC 22-16
Console(config)#ip telnet server
Console(config)#ip telnet port 123
Console(config)#