SMC Networks TigerAccess SMC7816M - Manual (Page 746)

VDSL C
OMMANDS
29-64
Command Usage
• Use this command without the interface parameter to display the
optional US0 band used for all VDSL ports on the switch, or with an
interface to display the optional band used for a specific port.
• Refer to the lre option-band command on page 29-6 for a list of the
frequency bounds for the optional band supported by this switch.
Example
This example shows that the optional US0 band used for Port 1.
Related Commands
lre option-band (29-6)
show lre ham-band
This command displays the HAM radio band that is blocked to VDSL
signals based on defined frequencies.
Syntax
show lre ham-plan [unit/port]
• unit - Stack unit. (Range: 1)
• port - Port number. (Range: 1-16)
Command Mode
Privileged Exec
Command Usage
• Use this command without the interface parameter to display the
HAM band frequency filter used for all VDSL ports on the switch, or
with an interface to display the filter used for a specific port.
• Refer to Table 29-4, “HAM Band Notches,” on page 29-7 for a list
of the stop bands for HAM radio frequencies supported by this
switch.
Console#show lre option-band 1/1
Optional Band : Annex A 6-32 26 to 138
kHz
Console#