SMC Networks TigerAccess SMC7816M - Manual (Page 736)

VDSL C
OMMANDS
29-54
the status of remote transceivers is obtained via the embedded
operation channel (EOC), this information may be unavailable for
units that are unreachable via the EOC during a line error condition.
Therefore, not all conditions may always be included in its current
status.
• This command sets the threshold for the number of initialization
failures within any 15 minute collection interval for performance data.
If the number of initialization failures in a particular 15-minute
collection interval reaches or exceeds this value, a
vdslInitFailureNotification notification will be generated. (Refer to
RFC 3728 for information on this notification message.) No more
than one notification will be sent per interval.
Example
The following sets the initialization failure threshold to 5.
thresh-15min-ess
This command sets the threshold for Errored Seconds (ESs) that can
occur within any given 15 minutes. Use the no form to restore the default
setting.
Syntax
thresh-15min-ess value
value – Threshold for Errored Seconds.
(Range: 0-900 seconds; 0 disables the threshold)
Default Setting
2
Command Mode
VDSL Alarm Profile
Console(config-alarm-profile)#init-failure 5
Console(config-alarm-profile)#