SMC Networks TigerAccess SMC7816M - Manual (Page 643)

25-1
C
HAPTER
25
I
NTERFACE
C
OMMANDS
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 25-1 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters
interface configuration mode GC 25-2
description Adds a description to an interface
configuration IC 25-3
speed-duplex Configures the speed and duplex
operation of a given interface when
autonegotiation is disabled IC 25-3
negotiation Enables autonegotiation of a given
interface IC 25-5
capabilities Advertises the capabilities of a given
interface for use in autonegotiation IC 25-6
flowcontrol Enables flow control on a given
interface IC 25-7
media-type Force port type selected for
combination ports IC 25-8
switchport mdix Sets pinout configuration to automatic
detection or fixed mode IC 25-9
shutdown Disables an interface IC 25-10
switchport packet-rate Configures broadcast and multicast
and unknown unicast storm control
thresholds
IC 25-11
clear counters Clears statistics on an interface PE 25-12
show interfaces status Displays status for the specified
interface
NE, PE 25-13