SMC Networks TigerAccess SMC7816M - Manual (Page 521)

21-1
C
HAPTER
21
SNMP C
OMMANDS
Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
SNMP Version 3 also provides security features that cover message
integrity, authentication, and encryption; as well as controlling user access
to specific areas of the MIB tree. To use SNMPv3, first set an SNMP
engine ID (or accept the default), specify read and write access views for
the MIB tree, configure SNMP user groups with the required security
model (i.e., SNMP v1, v2c or v3) and security level (i.e., authentication and
privacy), and then assign SNMP users to these groups, along with their
specific authentication and privacy passwords.
Table 21-1 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMP agent GC 21-2
show snmp Displays the status of SNMP
communications NE,
PE 21-3
snmp-server
community Sets up the community access string to
permit access to SNMP commands GC 21-4
snmp-server contact Sets the system contact string GC 21-5
snmp-server location Sets the system location string GC 21-5
snmp-server host Specifies the recipient of an SNMP
notification operation GC 21-6
snmp-server enable
traps Enables the device to send SNMP traps
(i.e., SNMP notifications) GC 21-9
rate-limit trap-input Sets an SNMP trap if traffic exceeds the
configured rate limit
IC 28-3