SMC Networks TigerAccess SMC7816M - Manual (Page 473)

S
YSTEM
M
ODE
C
OMMANDS
20-13
System Mode Commands
This section describes command used to configure the switch to operate in
normal mode or QinQ mode.
system mode
This command sets the switch to operate in QinQ mode. Use the no form
to restore the default setting of normal operating mode.
Syntax
system mode {normal | qinq | vlan-swap}
no system mode
• normal – Sets the switch to normal operating mode.
• qinq – Sets the switch to QinQ mode, and allows the dot1q tunnel
port to be configured. For an explanation of QinQ, see “Configuring
IEEE 802.1Q Tunneling” on page 32-25.
• vlan-swap – Sets the switch to VLAN Swap mode. For an explanation
of this feature, see “Configuring VLAN Swapping” on page 32-30.
Table 20-6 show memory status - display description
Field Description
free list The location and size of free system memory
current
free
Amount of memory currently free for use
allocated Amount of memory allocated to active processes
cumulative
allocated
Amount of memory allocated since the system was booted
Table 20-7 System Mode Commands
Command Function Mode Page
system mode Configures the switch to operate in normal
mode, QinQ mode, or VLAN-swap mode GC 20-13
show system mode Displays the switch system mode GC 20-14