Negotiation, Negotiation -5, 5 negotiation – SMC Networks TigerAccess SMC7816M User Manual
Page 647
NEGOTIATION
25-5
negotiation
This command enables autonegotiation for a given interface. Use the no
form to disable autonegotiation.
Syntax
[no] negotiation
Default Setting
Ports 1-16: Permanently disabled
Ports 17-19: Enabled
Command Mode
Interface Configuration (Ethernet - Ports 17-19, Port Channel)
Command Usage
• 1000BASE-T does not support forced mode. Auto-negotiation
should always be used to establish a connection over any
1000BASE-T port or trunk.
• When auto-negotiation is enabled the switch negotiate the best
settings for a link based on the capabilites command. When
auto-negotiation is disabled, you must manually specify the link
attributes with the speed-duplex and flowcontrol commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal
configuration will also be disabled for the RJ-45 ports.
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (25-6)
speed-duplex (25-3)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#