SMC Networks TigerAccess SMC7816M - Manual (Page 478)

S
YSTEM
M
ANAGEMENT
C
OMMANDS
20-18
settings will be set to default values when the system is rebooted
using this file.
• firmware - Keyword that allows you to copy BME firmware used
for upgrading CPEs to reserved buffer space in the switch. (BME
indicates the Burst Mode Engine used for digital signal processing.)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The system prompts for data required to complete the copy
command.
• The destination file name should not contain slashes (\ or /), the
leading letter of the file name should not be a period (.), and the
maximum length for file names on the TFTP server is 127 characters
or 31 characters for files on the switch. (Valid characters: A-Z, a-z, 0-9,
“.”, “-”, “_”)
• Due to the size limit of the flash memory, the switch supports only
two operation code files.
• The maximum number of user-defined configuration files depends on
available memory.
• You can use “Factory_Default_Config.cfg” as the source to copy
from the factory default configuration file, but you cannot use it as the
destination.
• To replace the startup configuration, you must use startup-config as
the destination.
• The Boot ROM and Loader cannot be uploaded or downloaded from
the TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.
• For information on specifying an https-certificate, see “Replacing the
Default Secure-site Certificate” on page 6-9. For information on
configuring the switch to use HTTPS for a secure connection, see “ip
http secure-server” on page 22-17.