SMC Networks TigerAccess SMC7816M - Manual (Page 735)

A
LARM
P
ROFILE
C
OMMANDS
29-53
Command Usage
First create a profile of VDSL alarm thresholds using the other
commands described in this section, then enter Global Configuration
mode to apply the profile to all VDSL ports on the switch using the lre
alarm-profile command. Or use the interface command to select a
specific port, and then use the lre alarm-profile command to apply the
settings to that interface.
Example
The following applies the alarm profile named southport to all VDSL
ports.
init-failure
This command sets the threshold for initialization failures that can occur
within any given 15 minutes. Use the no form to restore the default setting.
Syntax
init-failure value
value – Threshold for initialization failures.
(Range: 0-900 seconds; 0 disables the threshold)
Default Setting
1
Command Mode
VDSL Alarm Profile
Command Usage
• There are many factors which can cause an initialization failure,
including lossOfFraming, lossOfSignal, lossOfPower,
lossOfSignalQuality, lossOfLink, dataInitFailure, configInitFailure,
protocolInitFailure, or noPeerVtuPresent. All outstanding error
conditions associated with a VDSL transceiver are defined by the
vdslPhysCurrStatus bitmask in RFC 3728. However, note that since
Console(config)#lre alarm-profile southport
Console(config)#