SMC Networks TigerAccess SMC7816M - Manual (Page 733)

A
LARM
P
ROFILE
C
OMMANDS
29-51
Alarm Profile Commands
This section describes how to configure a list of threshold values for error
states which can be applied all VDSL ports or to a selected group of ports.
Table 29-8 Alarm Profile Commands
Command Function Mode Page
alarm-profile Enters VDSL Line Alarm configuration
mode GC 29-52
lre alarm-profile Applies an alarm profile to selected VDSL
ports GC/IC 29-52
init-failure Sets threshold for initialization failures in the
past 15 minutes VAP *
* VDSL Alarm Profile configuration mode.
29-53
thresh-15min-ess †
† When these thresholds are exceeded, notification messages are sent to
registered SNMP hosts as required by RFC 3728, reported to the syslog
system, and displayed on the console interface.
Sets threshold for Errored Seconds in the
past 15 minutes VAP 29-54
thresh-15min-lofs Sets threshold for Loss of Framing in the
past 15 minutes
VAP 29-55
thresh-15min-lols Sets threshold for Loss of Link in the past 15
minutes
VAP 29-56
thresh-15min-loss Sets threshold for Loss of Signal in the past
15 minutes
VAP 29-57
thresh-15min-lprs Sets threshold for Loss of Power in the past
15 minutes
VAP 29-58
thresh-15min-sess Sets threshold for Severely Errored Seconds
in the past 15 minutes
VAP 29-59
thresh-15min-uass Sets threshold for Unavailable Seconds in the
past 15 minutes
VAP 29-60