SMC Networks TigerAccess SMC7816M - Manual (Page 717)

L
INE
P
ROFILE
C
OMMANDS
29-35
Line Profile Commands
This section describes how to configure a list of communication
parameters such as data rates and acceptable noise margins which can be
applied to all VDSL ports or to a selected group of ports.
Table 29-7 Line Profile Commands
Command Function Mode Page
line-profile Enters VDSL Line Profile
configuration mode GC 29-36
lre line-profile Applies a line profile to selected VDSL
ports GC/IC 29-37
band-plan Sets the frequency bands used for
VDSL signals VLP * 29-38
option-band Sets the frequencies to be used for the
optional US0 band. VLP 29-39
ham-band Sets the HAM radio band that will be
blocked to VDSL signals based on
defined frequencies VLP 29-40
region-ham-band Sets the HAM radio band that will be
blocked to VDSL signals based on
defined usage types VLP 29-41
tone Disables VDSL signals at frequencies
less than or equal to 640 KHz, 1.1 MHz
or 2.2 MHz VLP 29-42
max-power Sets the maximum aggregate
downstream or upstream power VLP 29-43
min-protection Configures the minimum level of
impulse noise protection for all bearer
channels VLP 29-44
channel Sets the channel mode to fast or
interleaved VLP 29-45
down-max-inter-delay
up-max-inter-delay Sets the maximum interleave delay on a
downstream/upstream channel VLP 29-46