SMC Networks TigerAccess SMC7816M - Manual (Page 773)

CPE C
ONFIGURATION
29-91
Command Usage
• BME indicates the Burst Mode Engine used for digital signal
processing.
• This command activates the firmware version currently in inactive
state. It can therefore be used to activate the firmware version copied
to the CPE by the oam remote upgrade firmware command
(page 29-90).
• After using the copy tftp firmware command (page 29-87) to copy
BME firmware for CPEs to reserved buffer space in the switch, use
the oam remote upgrade firmware command (page 29-90) to
transfer the firmware to a remote CPE, and then use the oam remote
firmware active command (page 29-90) to activate the new firmware.
Example
Refer to the example under copy tftp firmware (page 29-87).
Related Commands
copy tftp firmware (page 29-87)
oam remote upgrade firmware (page 29-90)
show cpe-info
This command displays system information for a CPE connected to a
VDSL port.
Syntax
show cpe-info unit/port
• unit - Stack unit. (Range: 1)
• port - Port number. (Range: 1-16)
Command Mode
Privileged Exec