Chapter 27 mirror port commands, Port monitor, 27 mirror port commands -1 – SMC Networks TigerAccess SMC7816M User Manual
Page 675: Port monitor -1, Table 27-1 mirror port commands -1, Mirror port commands, 27 m, Hapter, Irror, Ommands
27-1
C
HAPTER
27
M
IRROR
P
ORT
C
OMMANDS
This section describes how to mirror traffic from a source port to a target
port.
port monitor
This command configures a mirror session. Use the no form to clear a
mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-18)
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Table 27-1 Mirror Port Commands
Command
Function
Mode Page
port monitor
Configures a mirror session
IC
show port monitor Shows the configuration for a mirror port
PE