SMC Networks TigerAccess SMC7816M - Manual (Page 630)

A
CCESS
C
ONTROL
L
IST
C
OMMANDS
24-16
MAC ACLs
The commands in this section configure ACLs based on hardware
addresses, packet format, and Ethernet type. To configure MAC ACLs,
first create an access list containing the required permit or deny rules, set a
precedence mask to control the filter sequence, and then bind the access
list to one or more ports
Table 24-3 MAC ACL Commands
Command Function Mode Page
access-list mac Creates a MAC ACL and enters
configuration mode GC 24-17
permit, deny Filters packets matching a specified
source and destination address,
packet format, and Ethernet type MAC-ACL 24-18
show mac access-list Displays the rules for configured
MAC ACLs
PE 24-20
access-list mac
mask-precedence Changes to the mode for configuring
access control masks GC 24-20
mask Sets a precedence mask for the ACL
rules MAC-Mask 24-21
show access-list mac
mask-precedence Shows the ingress or egress rule
masks for MAC ACLs PE 24-24
mac access-group Adds a port to a MAC ACL IC 24-25
show mac
access-group Shows port assignments for MAC
ACLs PE 24-26