Juniper Networks MX480 - Manual (Page 279)

Ramp Warning
WARNING: When installing the hardware equipment, do not use a ramp
inclined at more than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related
Documentation
General Safety Guidelines for Juniper Networks Devices on page 245 •
• General Safety Warnings for Juniper Networks Devices on page 246
• Maintenance and Operational Safety Warnings for Juniper Networks Devices on page 259
MX480 Chassis Lifting Guidelines
The weight of a fully configured chassis is about 163.5 lb (74.2 kg). Observe the following
guidelines for lifting and moving the router:
• Before moving the router, verify that the intended site meets the specified power,
environmental, and clearance requirements.
• Do not attempt to lift a fully configured router by yourself. Using a mechanical lift to
maneuver the router into a rack is recommended. If a lift cannot be used, a minimum
of two people must lift the router, and you must remove components from the chassis
before lifting.
255 Copyright © 2013, Juniper Networks, Inc.
Appendix A: Safety and Regulatory Compliance Information for the MX480 Router