Juniper Networks MX480 - Manual (Page 121)

CHAPTER 9
Connecting the MX480 Router
• Tools and Parts Required for MX480 Router Connections on page 97
• Connecting the MX480 Router to Management and Alarm Devices on page 97
• Connecting DPC, MPC, MIC, or PIC Cables to the MX480 Router on page 100
Tools and Parts Required for MX480 Router Connections
To connect the router to management devices and line cards, you need the following
tools and parts:
• Phillips (+) screwdrivers, numbers 1 and 2
• 2.5-mm flat-blade (–) screwdriver
• 2.5-mm Phillips (+) screwdriver
• Wire cutters
• Electrostatic discharge (ESD) grounding wrist strap
Related
Documentation
Connecting the MX480 Router to Management and Alarm Devices on page 97 •
Connecting the MX480 Router to Management and Alarm Devices
• Connecting the MX480 Router to a Network for Out-of-Band Management on page 97
• Connecting the MX480 Router to a Management Console or Auxiliary Device on page 98
• Connecting the MX480 Router to an External Alarm-Reporting Device on page 99
Connecting the MX480 Router to a Network for Out-of-Band Management
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
ETHERNET port on the Routing Engine. One
Ethernet cable is provided with the router. To connect to the ETHERNET port on the
Routing Engine:
1. Turn off the power to the management device.
2. Plug one end of the Ethernet cable ( Figure 60 on page 98 shows the connector) into
the ETHERNET port on the Routing Engine. Figure 59 on page 98 shows the port.
97 Copyright © 2013, Juniper Networks, Inc.