Juniper Networks T1600 User Manual
T1600 internet routing node upgrade guide
T1600 Internet Routing Node Upgrade
Guide
28 April 2008
Part Number: 530-021924-01
Revision 2
This guide provides procedures for upgrading an operational T640 Internet routing
node to a T1600 Internet routing node. These procedures include preparing the site,
replacing hardware, and verifying operation.
NOTE: Before you upgrade, the T640 routing node must be running JUNOS Release
8.5 or later.
Contents
T1600 Routing Node Overview .......................................................................3
T1600 Upgrade Kit ..........................................................................................5
Three-Input 240-A Power Supplies .....................................................6
T1600 Routing Node Upgrade Overview .......................................................10
Verifying the Hardware Version of the Rear Fan Tray ...................................11
Preparing the Site ..........................................................................................12
Typical Power Distribution ......................................................................12
Provisioning Additional Power for the T1600 Routing Node ...................13
Removing the Rear Fan Tray ..................................................................14
Installing a Rear Fan Tray .......................................................................15
Upgrading the DC Power Supplies .................................................................17
Preparing the DC Power Cables ..............................................................17
Tools and Parts Required ........................................................................17
Removing a Two-Input 160-A Power Supply ...........................................18
Setting the Input Mode Switch on a Three-Input 240-A Power
■
1
Document Outline
- Contents
- T1600 Routing Node Overview
- T1600 Upgrade Kit
- T1600 Routing Node Upgrade Overview
- Verifying the Hardware Version of the Rear Fan Tray
- Preparing the Site
- Replacing the Rear Fan Tray
- Upgrading the DC Power Supplies
- Preparing the DC Power Cables
- Tools and Parts Required
- Removing a Two-Input 160-A Power Supply
- Setting the Input Mode Switch on a Three-Input 240-A Power Supply
- Installing a Three-Input 240-A Power Supply
- Replacing the Cable Restraint on a Three-Input 240-A Power Supply
- Connecting a Three-Input 240-A Power Supply
- Powering On a Three-Input 240-A Power Supply
- Upgrading SIBs
- Removing the Upper Front Fan Tray
- Replacing the Craft Interface
- Installing the Upper Front Fan Tray
- Attaching the T1600 Agency Label
- Registering Your T1600 Upgrade
- T1600 Routing Node Environmental Specifications
- T1600 Routing Node DC Power Specifications
- Preventing Electrostatic Discharge Damage
- List of Technical Publications
- Documentation Feedback
- Requesting Technical Support