Troubleshooting the mx480 pics – Juniper Networks MX480 User Manual
Page 179
Temperature 24 degrees C / 75 degrees F
Total CPU DRAM 1024 MB
Total RLDRAM 128 MB
Total DDR DRAM 2048 MB
Start time: 2008-12-11 16:53:24 PST
Uptime: 15 hours, 2 minutes, 47 seconds
Max Power Consumption 368 Watts
Slot 2 information:
State Online
Temperature 29 degrees C / 84 degrees F
Total CPU DRAM 1024 MB
Total RLDRAM 256 MB
Total DDR DRAM 4096 MB
Start time: 2008-12-11 16:53:18 PST
Uptime: 15 hours, 2 minutes, 53 seconds
Max Power Consumption 294 Watts
Slot 3 information:
State Online
Temperature 29 degrees C / 84 degrees F
Total CPU DRAM 1024 MB
Total RLDRAM 256 MB
Total DDR DRAM 4096 MB
Start time: 2008-12-11 16:53:18 PST
Uptime: 15 hours, 2 minutes, 53 seconds
Max Power Consumption 335 Watts
Slot 4 information:
State Online
Temperature 29 degrees C / 84 degrees F
Total CPU DRAM 1024 MB
Total RLDRAM 256 MB
Total DDR DRAM 4096 MB
Start time: 2008-12-11 16:53:18 PST
Uptime: 15 hours, 2 minutes, 53 seconds
Max Power Consumption 333 Watts
For further description of the output from the commands, see the Junos OS System
Basics Configuration Guide.
Related
Documentation
MX480 Flexible PIC Concentrator (FPC) LEDs on page 18
•
•
Replacing an MX480 FPC on page 194
•
Holding an MX480 FPC on page 144
•
Storing an MX480 FPC on page 146
•
Maintaining MX480 FPCs on page 132
Troubleshooting the MX480 PICs
Problem
The PICs are not functioning normally.
Solution
Check the status of each port on a PIC by looking at the LED located on the PIC
faceplate. For information about the meaning of LED states on different PICs, see the
•
•
Check the status of a PIC by issuing the
show chassis fpc pic-status
CLI command. The
PIC slots in the FPC are numbered from
0
through
1
, left to right:
155
Copyright © 2013, Juniper Networks, Inc.
Chapter 13: Troubleshooting MX480 Hardware Components