Replacing mx480 power system components – Juniper Networks MX480 User Manual

Page 251

CAUTION:

After removing a transceiver from the chassis, wait at least 30

seconds before reinserting it or inserting a transceiver into a different slot.

Installing an SFP or XFP Transceiver into an MX480 DPC, MPC, MIC, or PIC

To install an SFP or XFP:

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.

Take each transceiver to be installed out of its electrostatic bag, and identify the slot
on the component where it will be installed.

Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
transceiver with a safety cap.

Carefully align the transceiver with the slots in the component. The connectors should
face the component.

Slide the transceiver until the connector is seated in the component slot. If you are
unable to fully insert the transceiver, make sure the connector is facing the right way.

Close the ejector handle of the transceiver.

Remove the rubber safety cap from the transceiver and the end of the cable. Insert
the cable into the transceiver.

WARNING:

Do not look directly into a fiber-optic transceiver or into the

ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.

Verify that the status LEDs on the component faceplate indicate that the SFP or XFP
is functioning correctly. For more information about the component LEDs, see the

Series 3D Universal Edge Routers Line Card Guide

Documentation

Preventing Electrostatic Discharge Damage to an MX480 Router on page 248

•

Replacing a Cable on an MX480 DPC, MPC, MIC, or PIC on page 222

Replacing MX480 Power System Components

•

Replacing an MX480 AC Power Supply on page 228

•

Replacing an MX480 DC Power Supply on page 230

•

Replacing an MX480 AC Power Supply Cord on page 235