Juniper Networks MX480 - Manual (Page 107)

CHAPTER 8
Installing the MX480 Router Without a
Mechanical Lift
• Tools Required to Install the MX480 Router Without a Mechanical Lift on page 83
• Removing Components from the MX480 Router Before Installing It Without a
Lift on page 83
• Installing the MX480 Chassis in the Rack Manually on page 89
• Reinstalling Components in the MX480 Router After Installing It Without a
Lift on page 91
Tools Required to Install the MX480 Router Without a Mechanical Lift
To install the router, you need the following tools and parts:
• Phillips (+) screwdrivers, numbers 1 and 2
• 7/16-in. (11 mm) nut driver
• ESD grounding wrist strap
Related
Documentation
Removing Components from the MX480 Router Before Installing It Without a Lift on
page 83 •
• Installing the MX480 Chassis in the Rack Manually on page 89
• Reinstalling Components in the MX480 Router After Installing It Without a Lift on
page 91
Removing Components from the MX480 Router Before Installing It Without a Lift
If you cannot use a mechanical lift to install the router (the preferred method), you can
install it manually. To make the router light enough to install manually, you first remove
most components from the chassis. The procedures for removing components from the
chassis are for initial installation only, and assume that you have not connected power
83 Copyright © 2013, Juniper Networks, Inc.