Juniper Networks E-Series User Manual
E-series routers installation and user guide
Table of contents
Document Outline
- Installation and User Guide
- Installing and Using E-Series Routers
- E-Series Overview
- Unpacking and Inspecting E-Series Routers
- Installation Guidelines and Requirements
- Installing E-Series Routers
- Installing Modules
- Cabling E-Series Routers
- Powering Up E-Series Routers
- Accessing E-Series Routers
- Maintaining E-Series Routers
- Troubleshooting
- System and Module Specifications
- Appendixes
- Cable Pinouts
- Installing JUNOSe Software
- Overview
- Installing Software When a Firewall Exists
- Task 1: Obtain the Required Information
- Task 2: Divert Network Traffic to Another Router
- Task 3: Access Privileged Exec Mode
- Task 4: Configure IP on an Interface
- Task 5: Mount the CD on the Network Host
- Task 6: Configure Access to the Network Host
- Task 7: Enable the FTP Server on the E-Series Router
- Task 8: Identify the Files to Transfer
- Task 9: Transfer Files to the User Space
- Task 10: Install Files on the System Space
- Task 11: Save the Current Configuration
- Task 12: Reboot the System
- Installing Software When a Firewall Does Not Exist
- Installing Software in Normal Operational Mode
- Task 1: Obtain the Required Information
- Task 2: Divert Network Traffic to Another Router
- Task 3: Access Privileged Exec Mode
- Task 4: Configure IP on an Interface
- Task 5: Configure Access to the Network Host
- Task 6: Mount the CD on the Network Host
- Task 7: Copy the Software Release File
- Task 8: Save the Current Configuration
- Task 9: Reboot the System
- Installing Software in Boot Mode
- Installing Software in Normal Operational Mode
- Copying Release Files from One E-Series Router to Another
- Upgrading Systems That Are Operating with Two SRP Modules
- Customer Support
- Declaration of Conformity
- Index