Juniper Networks SRX 210 User Manual
Page 96
4.
Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
device (see
5.
Connect the other end of the Ethernet cable to the console port on the services
gateway (see
6.
Turn on the power to the management device.
7.
Start your asynchronous terminal emulation application (such as Microsoft Windows
HyperTerminal) and select the appropriate
COM
port to use (for example,
COM1
).
8.
Configure the port settings shown in
Table 30: Port Settings for Connecting to the Console Port
Value
Port Settings
9600
Bits per second
8
Data bits
None
Parity
1
Stop bits
None
Flow control
9.
Power on the services gateway by pressing the Power button on the front panel.
10.
Verify that the Power LED on the front panel turns green.
The terminal emulation screen on your management device displays the startup
sequence. When the services gateway has finished starting up, a login prompt appears.
11.
Log in as the user
root
. No password is required at initial connection, but you must
assign a root password before committing any configuration settings.
Related
Documentation
Connecting an SRX210 Services Gateway to the CLI Remotely on page 80
•
•
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
CLI on page 89
•
SRX210 Services Gateway Software Configuration Overview on page 85
•
SRX210 Services Gateway Secure Web Access Overview on page 95
Connecting an SRX210 Services Gateway to the CLI Remotely
You can connect an SRX210 Services Gateway to the CLI from a remote location through
two dial-up modems:
•
A modem that is connected to the console port on the services gateway
•
A second modem connected to a remote management device
Copyright © 2013, Juniper Networks, Inc.
80
SRX210 Services Gateway Hardware Guide