Juniper Networks SRX 210 - Manual (Page 83)

CHAPTER 12
Connecting, Grounding, and Powering On
the SRX210 Services Gateway
This chapter includes the following topics:
• Connecting the SRX210 Services Gateway to the Power Supply on page 67
• Connecting and Organizing Interface Cables for the SRX210 Services
Gateway on page 68
• Grounding the SRX210 Services Gateway on page 70
• Powering On and Powering Off the SRX210 Services Gateway on page 71
Connecting the SRX210 Services Gateway to the Power Supply
To connect the device to the power supply:
CAUTION: Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
NOTE: If you are installing your services gateway on a desk, ensure that your
device is adequately grounded using the grounding point on the back panel
of the chassis.
1. Plug the DC connector end of the power cable into the power connector on the back
of the device (see
Figure 22 on page 68 ).
2. Plug the AC adapter end of the power cable into an AC power outlet.
67 Copyright © 2013, Juniper Networks, Inc.