Juniper Networks SRX 210 User Manual
Page 71
Preparing the SRX210 Services Gateway for Desk-Mount Installation
You can mount an SRX210 Services Gateway on a desk or other level surface horizontally
or vertically. The four rubber feet attached to the chassis provide stability.
provides the list of tasks you need to perform before installing the
device.
Table 25: SRX210 Services Gateway Preinstallation Checklist for
Desk-Mount Installation
Additional Information
Task
“Site Preparation Checklist for the SRX210
Services Gateway” on page 37
Verify that the site meets the requirements.
Place the desk in its permanent location, allowing
adequate clearance for airflow and maintenance,
and secure it to the building structure.
“Unpacking the SRX210 Services Gateway”
on page 49
Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available in
your desk-mounting kit to mount the SRX210
Services Gateway vertically:
•
Vertical stand
•
Screws
NOTE:
If you are mounting the services gateway horizontally on a desk, verify
that the rubber feet are attached to the chassis.
NOTE:
The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Related
Documentation
Clearance Requirements for Airflow and Hardware Maintenance of the SRX210 Services
Gateway on page 41
•
•
Unpacking the SRX210 Services Gateway on page 49
•
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 53
•
Preparing the SRX210 Services Gateway for Wall-Mount Installation on page 56
55
Copyright © 2013, Juniper Networks, Inc.
Chapter 10: Preparing the SRX210 Services Gateway for Installation