Juniper Networks SRX 210 - Manual (Page 72)

Preparing the SRX210 Services Gateway for Wall-Mount Installation
You can mount an SRX210 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Table 26 on page 56 provides the list of tasks you need to perform before installing the
device.
Table 26: SRX210 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Additional Information Task
“Site Preparation Checklist for the
SRX210 Services Gateway” on page 37 Verify that the site meets the requirements.
“Unpacking the SRX210 Services
Gateway” on page 49 Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available in
your wall-mounting kit to mount the SRX210 Services
Gateway on wall:
• Wall-mounting brackets
• Screws
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
• Unpacking the SRX210 Services Gateway on page 49
• Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 53
• Preparing the SRX210 Services Gateway for Desk-Mount Installation on page 55
Copyright © 2013, Juniper Networks, Inc. 56
SRX210 Services Gateway Hardware Guide