beautypg.com

Resetting the srx210 services gateway – Juniper Networks SRX 210 User Manual

Page 89

background image

TIP:

When you are powering off the device, the system displays the following

message:

Turning the system power off

. You can now safely remove the power

cable to completely disconnect the power from the device.

NOTE:

You can use the

request system reboot

command to schedule a reboot

of the services gateway.

For more information about halting, powering off, or rebooting the services gateway using
the CLI, see the following topics:

Initial Configuration for Security Devices

Monitoring and Troubleshooting for Security Devices

Resetting the SRX210 Services Gateway

The Reset Config button located at the front panel of the SRX210 Services Gateway
removes the current configuration and resets the device to the default configuration. The
button is recessed in the front panel to prevent it from being pressed accidentally.

NOTE:

Pressing and holding the Reset Config button for 15 seconds or more

deletes all configurations on the device and loads and commits the factory
configuration.

Related

Documentation

Connecting the SRX210 Services Gateway to the Power Supply on page 67

Grounding the SRX210 Services Gateway on page 70

SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 9

Using the Reset Config Button on the SRX210 Services Gateway on page 109

SRX210 Services Gateway LEDs on page 13

73

Copyright © 2013, Juniper Networks, Inc.

Chapter 12: Connecting, Grounding, and Powering On the SRX210 Services Gateway