Juniper Networks SRX 210 - Manual (Page 121)

Table 37: Component LEDs on the Services Gateway (continued)
Possible Causes and
Corrective Actions
Meaning State LED
The device is not part of the
chassis cluster setup. Off HA LED
Normal condition. No action
is required. The Mini-PIM is present and
detected by the device. Green Mini-PIM LED
See “Monitoring the SRX210
Services Gateway Using
Chassis Alarm Conditions”
on page 105
.
The Mini-PIM is not present
or is not detected by the
device. Off
Related
Documentation
Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 101 •
• Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 105
• Monitoring the SRX210 Services Gateway Power System on page 108
• Using the Reset Config Button on the SRX210 Services Gateway on page 109
• Changing the Reset Config Button Behavior on the SRX210 Services Gateway on page 110
• Juniper Networks Technical Assistance Center on page 110
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions
When the services gateway detects an alarm condition, the alarm LED on the front panel
turns red or amber as appropriate.
To view a more detailed description of the cause of the alarm , issue the show chassis
alarms CLI command.
For more information on the show chassis alarms command, see the following topics:
• Initial Configuration for Security Devices
• Monitoring and Troubleshooting for Security Devices
Table 38 on page 106 describes alarms that can occur for an SRX210 Services Gateway
chassis component.
105 Copyright © 2013, Juniper Networks, Inc.
Chapter 17: Monitoring the SRX210 Services Gateway