Gateway – Juniper Networks SRX 210 User Manual

Page 84

Figure 22: Connecting the SRX210 Services Gateway to the Power Supply

NOTE:

The device must be connected to earth ground during normal

operation. The protective earthing terminal on the rear of the chassis is
provided to connect the device to ground.

CAUTION:

We recommend using a surge protector for the power connection.

NOTE:

Use the cable tie holder to secure the power cord on to the power

supply point.

NOTE:

We strongly recommend that you use only the 3-prong power cord

supplied with your services gateway. If you are using a 2-prong power cord,
then ensure that your device is adequately grounded using the grounding
point available on the back panel of the chassis.

Documentation

Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway
on page 47

•

Grounding the SRX210 Services Gateway on page 70

•

Connecting and Organizing Interface Cables for the SRX210 Services Gateway on
page 68

•

SRX210 Services Gateway General Safety Guidelines and Warnings on page 115

Connecting and Organizing Interface Cables for the SRX210 Services Gateway

You can connect the interfaces installed in the services gateway to various network
media. Each type of interface on the services gateway uses a particular medium to

SRX210 Services Gateway Hardware Guide