beautypg.com

Powering off the srx210 services gateway – Juniper Networks SRX 210 User Manual

Page 88

background image

NOTE:

After the power supply is turned on, it can take up to 60 seconds for

status indicators—such as the Status and Power LEDs—to show that the
power supply is functioning normally.

NOTE:

We recommend issuing the CLI command

request system power-off

when you want to power off the device immediately after the device is
powered on.

Powering Off the SRX210 Services Gateway

You can power off the services gateway in one of the following ways:

Graceful shutdown — Press and release the Power button. The device begins gracefully
shutting down the operating system and then powers itself off.

Forced shutdown — Press the Power button and hold it for more than ten seconds.
The device immediately powers itself off without shutting down the operating system.

NOTE:

Do not press the Power button while the device is shutting down.

WARNING:

Use the graceful shutdown method to halt, power off, or reboot

the services gateway. Use the forced shutdown method as a last resort to
recover the services gateway if the services gateway operating system is
not responding to the graceful shutdown method.

CAUTION:

Forced shutdown can result in data loss and corruption of the

file system.

NOTE:

To remove power completely from the device, unplug the AC power

cord or switch off the power source.

After powering off a power supply, wait at least 10 seconds before turning it
back on. After powering on a power supply, wait at least 10 seconds before
turning it off.

The Power button on the services gateway is a standby power switch.

If you press the Power button to power off the device when it is still connected
to a power source, 12 V (Low Memory and High Memory models) /48 V (PoE
models) power will still be available in the chassis and the device will be fully
powered off.

Copyright © 2013, Juniper Networks, Inc.

72

SRX210 Services Gateway Hardware Guide