Juniper Networks SRX 210 - Manual (Page 95)

• Connecting an SRX210 Services Gateway to the CLI Locally on page 79
• SRX210 Services Gateway Software Configuration Overview on page 85
• SRX210 Services Gateway Secure Web Access Overview on page 95
Connecting an SRX210 Services Gateway to the CLI Locally
If you plan to use the CLI to configure the SRX210 Services Gateway, you must connect
through the console port, as shown in
Figure 25 on page 79 .
Figure 25: Connecting to the Console Port on an SRX210 Services Gateway
NOTE: Figure 25 on page 79 shows a connection to a local management
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (provided in the services gateway
accessory box), plus a DB-9 male to DB-25 male (or similar) adapter for your
modem, which you must purchase separately.
To connect to the CLI using a local management device through the console port on the
services gateway:
1. Turn off power to the services gateway.
2. Turn off power to the management device, such as a PC or laptop computer, that you
are using to access the CLI.
3. Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45
to DB-9 serial port adapter supplied with your services gateway (see
Figure 25 on page 79 ).
79 Copyright © 2013, Juniper Networks, Inc.
Chapter 14: Connecting the SRX210 Services Gateway to Management Devices