Juniper Networks SRX 210 - Manual (Page 122)

Table 38: SRX210 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Alarm
Severity
Action Alarm Condition Component
Amber
(minor) • If the internal flash memory fails at startup,
the services gateway automatically boots
from the alternative boot device (USB
storage device).
NOTE: If you configured your services
gateway to boot from an alternative boot
device, ignore this alarm condition.
• Reformat the internal flash memory, and
install a bootable image. (See the
Initial
Configuration for Security Devices and
Monitoring and Troubleshooting for
Security Devices
.)
• If you did not configure the services
gateway to boot from an alternative boot
device, contact Juniper Networks Technical
Assistance Center (JTAC). See
“Juniper
Networks Technical Assistance Center” on
page 110
.
The services
gateway boots from
an alternate boot
device. Boot media
Red
(major) • Contact the Juniper Networks Technical
Assistance Center (JTAC). See
“Juniper
Networks Technical Assistance Center” on
page 110
.
• If you must replace the failed Mini-PIM, see
the
SRX Series Services Gateways for
the Branch Physical Interface Modules
Hardware Guide
for information about
replacing the Mini-PIMs.
A Mini-PIM has
failed. Mini-Physical
Interface
Module
(Mini-PIM)
Copyright © 2013, Juniper Networks, Inc. 106
SRX210 Services Gateway Hardware Guide