Juniper Networks SRX 210 - Manual (Page 43)

Figure 11: Installing the 3G ExpressCard in the SRX210 Services Gateway
3. Insert the 3G ExpressCard slowly and firmly into the ExpressCard slot until the 3G
ExpressCard is engaged in the slot as follows:
• The 3G ExpressCard is designed to fit tightly in the slot. You will encounter two
points of resistance while inserting the 3G ExpressCard into the slot. Use firm
pressure as you insert the card.
• You will encounter the first point of resistance when you begin to insert the 3G
ExpressCard. After you align the 3G ExpressCard, lift the card slightly and use firm
pressure to slide it into the slot.
• When you have partially inserted the 3G ExpressCard, you will encounter the second
point of resistance. Use additional pressure to finish inserting the 3G ExpressCard
into the slot.
Related
Documentation
SRX210 Services Gateway 3G ExpressCard Overview on page 23 •
• SRX210 Services Gateway 3G ExpressCard Basic CLI Commands on page 27
SRX210 Services Gateway 3G ExpressCard Basic CLI Commands
Table 13 on page 27 lists the basic CLI commands for operating the 3G ExpressCard on
the SRX210 Services Gateway.
The 3G wireless interface uses the prefix cl in the syntax cl-slot-number/0/port number .
Table 13: SRX210 Services Gateway 3G ExpressCard Basic CLI Commands
Command Action
show modem wireless interface cl-0/0/8
show interfaces terse
Checks the status of the 3G ExpressCard.
CDMA ExpressCards
27 Copyright © 2013, Juniper Networks, Inc.
Chapter 3: SRX210 Services Gateway 3G ExpressCard