Hitachi TAGMASTORE MK-90RD011-25 - Manual (Page 362)

344 Chapter 5 Troubleshooting
Table 5.3 Command Error Messages
Error Code Error Message Condition Recommended Action Value
EX_COMERR Can’t be
communicated with
HORC Manager
This command failed to
communicate with the CCI software.
Verify that HORCM is running by using UNIX
commands [ps - ef | grep horcm].
255
EX_REQARG Required Arg list An option or arguments of an option
are not sufficient.
Please designate the correct option using the -h
option.
254
EX_INVARG Invalid argument An option or arguments of an option
are incorrect.
Please designate the correct option using the -h
option.
253
EX_UNWOPT Unknown option Designated an unknown option. Please designate the correct option using the -h
option.
252
EX_ATTHOR Can’t be attached to
HORC Manager
Could not connect with HORCM. Please verify that HORCM is running and/or that
HORCMINST is set correctly.
251
EX_ATTDBG Can’t be attached to
a Debug layer
Failed to communicate with
HORCM, or cannot make a log
directory file.
Verify that HORCM is running by using UNIX
commands [ps - ef | grep horcm].
250
EX_INVNAM Invalid name of
option
The name specified in an argument
of an option is not appropriate.
Please designate the correct option using the -h
option.
249
EX_OPTINV A specified option is
invalid
Detected contradiction in information
which RAID reported.
Call the Hitachi Data Systems Support Center. 248
EX_ENOENT No such device or
group
The designated device or group
name does not exist in the
configuration file.
Verify the device or group name and add it to the
configuration file of the remote and local hosts.
247
EX_ENODEV No such device The designated device name does
not exist in the configuration file.
Verify the device name and add it to the
configuration file of the remote and local hosts.
246
EX_ENOUNT No such RAID unit The designated RAID unit ID does
not exist in the configuration file.
Verify the RAID unit ID and add it to the
configuration file of the remote and local hosts.
219
EX_ENQSER Unmatched Serial#
vs RAID unitID
The group designated by
ShadowImage paircreate does not
have the same RAID unit, or the
unitID is not identical to the unit ID in
the same RAID serial# (Seq#).
Please confirm serial# (Seq#) using the
pairdisplay command, or confirm serial# (Seq#) of
the RAID storage system using the raidqry -r
command
218
EX_ENOMEM Not enough core Insufficient memory exists. Increase the virtual memory capacity of the
system, or close any unnecessary programs
and/or daemon processes.
245
EX_ERANGE Result too large Tried to use arguments for an option
beyond the maximum allowed, or a
result beyond the maximum was
created.
Please refer to the error message, and designate
an appropriate value.
244
EX_ENAMLG File name too long Undefined error. Call the Hitachi Data Systems Support Center. 243
EX_ENORMT No remote host
alive for remote
commands or
remote HORCM
might be blocked
(sleeping) on an
existing I/O
A timeout occurred on remote
communication, and HORC Manager
failed to re-execute.
Please confirm that the HORC Manager in the
remote host is running, and then increase the
value of the timeout in the configuration file.
242
EX_INVMOD Invalid RAID
command mode
Detected a contradiction for a
command.
Call the Hitachi Data Systems Support Center. 241