Hitachi TAGMASTORE MK-90RD011-25 - Manual (Page 269)

Hitachi Command Control Interface (CCI) User and Reference Guide 251
# raidvchkscan -p CL1-A -v cflag
PORT# /ALPA/C TID# LU# Seq# Num LDEV# BR-W-E-E MR-W-B BR-W-B-Z SR-W-B-S
CL1-A / ef/ 0 0 0 2332 1 0 D E B R D D D D E E E D E D D
CL1-A / ef/ 0 0 1 2332 1 1 D E B R D D D D E E E D E D D
Figure 4.40 Raidvchkscan Command Example with -v cflag Option
Output of the raidqvchkscan command with -v cflag option:
„
BR-W-E-E: This column displays the flags for checking regarding data block size.
R = E: Checking for data block size on Read is enabled.
D: Checking for data block size on Read is disabled.
W = E: Checking for data block size on Write is enabled.
D: Checking for data block size on Write is disabled.
E = L: Data block on Read/Write is interpreted as little endian format.
B: Data block on Read/Write is interpreted as big endian format.
E = W: Warning that Read/Write is not rejected when validation error is detected.
C: Read/Write is rejected when validation error is detected.
„
MR-W-B: This column displays the flags for checking regarding CHK-F3 in the data block.
R = E: Checking for CHK-F3 on Read is enabled.
D: Checking for CHK-F3 on Read is disabled.
W = E: Checking for CHK-F3 on Write is enabled.
D: Checking for CHK-F3 on Write is disabled.
B = E: Checking for CHK-F3 in the data block #0 is enabled.
D: Checking for CHK-F3 in the data block #0 is disabled.
„
BR-W-B-Z: This column displays the flags for checking regarding CHK-F2 in the data
block.
R = E: Checking for CHK-F2 on Read is enabled.
D: Checking for CHK-F2 on Read is disabled.
W = E: Checking for CHK-F2 on Write is enabled.
D: Checking for CHK-F2 on Write is disabled.
B = E: Comparing for CHK-F2 in the data block is enabled.
D: Comparing for CHK-F2 in the data block is disabled.
Z = E: The NON zero checking for CHK-F2 in the data block shows to being enabled.
D: The NON zero checking for CHK-F2 in the data block shows to being disabled.