Hitachi TAGMASTORE MK-90RD011-25 - Manual (Page 179)

Hitachi Command Control Interface (CCI) User and Reference Guide 161
3. Setting the user account.
The system administrator must set the user account for the CCI administrator as needed.
In case of using GUI, use “Administrative ToolsÆServicesÆSelect HORCM0ÆLogon”.
In case of using CUI, use “sc config” command as follows:
C:\HORCM\tool\>sc config HORCM0 obj= AccountName password=
password
If the system administrator uses default account (LocalSystem), add
“HORCM_EVERYCLI=1”:
# **** For INSTANCE# X, change to HORCMINST=X as needed ****
START:
set HORCM_EVERYCLI=1
set HORCMINST=0
set HORCC_LOG=STDERROUT
C:\HORCM\etc\horcmstart.exe
exit 0
4. Starting the HORCM instance from the service.
After you have confirmed starting and stopping using “horcmstart 0” and
“horcmshutdown 0”, you must verify that HORCM0 starts from the service and that
HORCM0 started automatically from REBOOT, using the following command:
C:\HORCM\tool\>net start HORCM0
5. Stopping HORCM instance as a service.
Instead of using the “horcmshutdown 0” command, you must use the following command
to stop HORCM0:
C:\HORCM\tool\>net stop HORCM0
(By using the “horcmshutdown 0” command, the script written into HORCM0_run.txt will
automatically restart HORCM0).