Hitachi TAGMASTORE MK-90RD011-25 - Manual (Page 342)

324 Chapter 4 Performing CCI Operations
4.21.2 SLPR Configuration Examples
4.21.2.1 Single Host
Figure 4.81 provides an example of when control is denied to the paircreate and raidscan
commands in the following cases:
„
The volume described on RM INST1 is different from the SLPR of the command device, so
the paircreate command cannot control the paired volume.
„
The specified port is different from the SLPR of the command device, so the raidscan -p
CL3-A command cannot scan any ports that are defined as SLPR#N.
SLPR0 SLPR# M SLPR# N
Host
RM
INST0
RM
INST1
CM
PVOL SVOL
CL1-A CL3-A
Figure 4.81 SLPR Configuration on a Single Host
To operate SLPR#N, assign the command device. If RM INST1 has a command device for
SLPR#N, the paircreate command is permitted. However, the raidscan -p CL3-A command
(via RMINST0) will be unable to scan a port, because the specified port is different than the
SLPR of the command device. In this case, -p CL3-A must be operated via RMINST1, as shown
in the following example.