Hitachi TAGMASTORE MK-90RD011-25 - Manual (Page 260)

242 Chapter 4 Performing CCI Operations
4.12.2 Raidvchkdsp Command
The raidvchkdsp command displays the parameters for validation checking of the specified
volumes. Unit of checking for the validation is based on the group of CCI configuration
definition file. Table 4.30 lists and describes the raidvchkdsp command parameters. Figure
4.34 - Figure 4.36 show examples of the raidvchkdsp command.
Note: This command will be controlled as protection facility. Non-permitted volume is
shown without LDEV# information (LDEV# information is “ – ”). This command will be
rejected with EX_ERPERM by connectivity checking between CCI and the storage system.
Table 4.30 Raidvchkdsp Command Parameters
Parameter Value
Command Name raidvchkdsp
Format raidvchkdsp { -h ⎪ -q ⎪ -z ⎪ -g ⎪ -d -d[g] [MU#]
⎪ -d[g] [MU#] ⎪ -f[xde] ⎪ -v ⎪ -c }