Hitachi TAGMASTORE MK-90RD011-25 - Manual (Page 258)

240 Chapter 4 Performing CCI Operations
Parameter Value
-vg [type]: Specifies the following guard type to the target volumes for Data Retention Utility (Open LDEV
Guard on 9900V). If [type] is not specified, this option will disable all of the guarding.
inv: The target volumes are concealed from SCSI Inquiry command by responding “unpopulated volume”.
sz0: The target volumes replies with “SIZE 0” through SCSI Read capacity command.
rwd: The target volumes are disabled from reading and writing.
wtd: The target volumes are disabled from writing.
svd: If the target volume is SMPL, it is protected from paircreate (from becoming an SVOL).
If the target volume is PVOL, it is protected from pairresync restore or pairresync swaps(p).
If the target volume is SVOL_PSUS(SSUS), it is protected from pairresync synchronous copy.
[rtime]: Specifies the retention time, in units of day. If [rtime] is not specified, the default time defined by
the storage system will be used. The default time is “zero” in 9900V microcode version 21-08-xx. This
option is ignored (default = infinite) in 9900V microcode version 21-06-xx or 21-07-xx.
This option sets each four flags for guarding type as follows:
type INQ RCAP READ WRITE
inv 1 1 1 1
Sz0 0 1 1 1
rwd 0 0 1 1
wtd 0 0 0 1
Returned values The command sets either of the following returned values in exit(), which allows users to check the
execution results using a user program.
Normal termination: 0
Abnormal termination:
The raidvchkset -vg option command returns the following error code (see Table 4.28 below) as well as
generic error (refer to Table 5.3).
Table 4.28 Specific Error Code for raidvchkset -vg Option
Category Error Code Error Message Recommended Action Value
Volume Status
Unrecoverable EX_EPRORT Mode changes denied
due to retention time
Please confirm the retention time for a target
volume by using raidvchkscan -v gflag command.
208