PLANET WGSW-52040 - Manual (Page 92)

3. Display the configuration of port isolation
Command Explanation
Admin Mode and Global Mode
show isolate-port group [ ]
Display the configuration of port isolation,
including all configured port isolation groups
and Ethernet ports in each group.
8.3 Port Isolation Function Typical Examples
Figure 8-1: Typical example of port isolation function
The topology and configuration of switches are showed in the figure above, with e1/1, e1/10
and e1/15 all belonging to VLAN 100. The requirement is that, after port isolation is enabled on
switch S1, e1/1 and e1/10 on switch S1 can not communicate with each other, while both of
them can communicate with the uplink port e1/15. That is, the communication between any
pair of downlink ports is disabled while that between any downlink port and a specified uplink
port is normal. The uplink port can communicate with any port normally.
The configuration of S1:
Switch(config)#isolate-port group test
Switch(config)#isolate-port group test switchport interface ethernet 1/1;1/10
e1/1
e1/15
Vlan
S1 e1/10
S3 S2
8-14