PLANET WGSW-52040 - Manual (Page 88)

loopback
no loopback
Enables/Disables loopback test function for
specified ports.
storm control {unicast | broadcast |
multicast } {kbps | pps }
no strom control {unicast | broadcast |
multicast}>
Enables the storm control function for
broadcasts, multicasts and unicasts with
unknown destinations (short for broadcast),
and sets the allowed broadcast packet
number or the bit number passing per
second; the no format of this command
disables the broadcast storm control
function.
switchport flood-control
{ bcast|mcast|ucast }
no switchport flood-control
{ bcast|mcast|ucast }
Configure that switch does not transmit
broadcast, unknown multicast or unknown
unicast packets any more to the specified
port; no command restores the default
configuration. Note: This switch does not
support this command.
port-scan-mode {interrupt | poll}
no port-scan-mode
Configure port-scan-mode as interrupt or poll
mode, the no command restores the default
port-scan-mode.
rate-violation <200-2000000> [recovery
<0-86400>]
no rate-violation
Set the max packet reception rate of a port. If
the rate of the received packet violates the
packet reception rate, shut down this port
and configure the recovery time, the default
is 300s. The no command will disable the
rate-violation function of a port.
Command Explanation
Port Mode
switchport discard packet { all |
untag }
no switchport discard packet { all |
untag }
Configure the port not to receive any packet
or untag; the no command cancel the
restriction of discard, it means the port is
allowed to receive any packet or untag.
Command Explanation
Global Mode
port-rate-statistics interval
-value>
Configure the interval of port-rate-statistics.
7-10