PLANET WGSW-52040 - Manual (Page 336)

(11) Configuring a standard IPv6 access-list based on nomenclature
a) Create a standard IPv6 access-list based on nomenclature
b) Specify multiple permit or deny rule entries
c) Exit ACL Configuration Mode
2. Configuring the packet filtering function
(1) Enable global packet filtering function
(2) Configure default action
3. Configuring time range function
(1) Create the name of the time range
(2) Configure periodic time range
(3) Configure absolute time range
4. Bind access-list to an incoming direction of the specified port
5. Clear the filtering information of the specified port
1. Configuring access-list
(1) Configuring a numbered standard IP access-list
Command Explanation
Global Mode
access-list {deny | permit} {{
} | any-source | {host-source }}
no access-list
Creates a numbered standard IP
access-list, if the access-list
already exists, then a rule will
add to the current access-list;
the “no access-list
“ command deletes a
numbered standard IP
access-list.
(2) Configuring a numbered extensive IP access-list
Command Explanation
Global Mode
access-list {deny | permit} icmp {{
} | any-source | {host-source }}
{{ } | any-destination |
{host-destination }} [
[]] [precedence ] [tos
][time-range]
Creates a numbered ICMP
extended IP access rule; if the
numbered extended access-list
of specified number does not
exist, then an access-list will be
created using this number.
41-115