PLANET WGSW-52040 - Manual (Page 87)

1. Enter the Ethernet port configuration mode
Command Explanation
Global Mode
interface ethernet Enters the network port configuration mode.
2. Configure the properties for the Ethernet ports
Command Explanation
Port Mode
media-type {copper |
copper-preferred-auto | fiber |
sfp-preferred-auto}
Sets the combo port mode (combo ports
only).
shutdown
no shutdown
Enables/Disables specified ports.
description
no description
Specifies or cancels the name of specified
ports.
mdi {auto | across | normal}
no mdi
Sets the cable type for the specified port; this
command is not supported by combo port
and fiber port of switch.
speed-duplex {auto [10 [100 [1000]]
[auto | full | half |]] | force10-half |
force10-full | force100-half |
force100-full | force100-fx
[module-type {auto-detected |
no-phy-integrated | phy-integrated}] |
{{force1g-half | force1g-full}
[nonegotiate [master | slave]]}|
force10g-full}
no speed-duplex
Sets port speed and duplex mode of
100/1000Base-TX or 100Base-FX ports. The
no format of this command restores the
default setting, i.e., negotiates speed and
duplex mode automatically.
negotiation {on|off}
Enables/Disables the auto-negotiation
function of 1000Base-FX ports.
bandwidth control [both |
receive | transmit]
no bandwidth control
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports.
flow control
no flow control
Enables/Disables traffic control function for
specified ports.
7-9