PLANET WGSW-52040 - Manual (Page 408)

ipv6 security-ra enable
no ipv6 security-ra enable
Enable and disable IPv6 security RA in port
configuration mode.
3. Display and debug the relative information of IPv6 security RA
Command Explanation
Admin Mode
debug ipv6 security-ra
no debug ipv6 security-ra
Enable the debug information of IPv6
security RA module, the no operation of
this command will disable the output of
debug information of IPv6 security RA.
show ipv6 security-ra [interface
]
Display the distrust port and whether
globally security RA is enabled.
49.3 IPv6 Security RA Typical Examples
Other IPv6 network
PC User
RA Ethernet1/1
Ethernet1/2
RA
X
Ethernet1/3
Illegal User
Figure 49-1: IPv6 Security RA sketch map
Instructions: if the illegal user in the graph advertises RA, the normal user will receive the RA,
set the default router as the vicious IPv6 host user and change its own address. This will cause
the normal user to not be able to connect the network. We want to set security RA on the 1/2
port of the switch, so that the RA from the illegal user will not affect the normal user.
49-187