PLANET WGSW-52040 - Manual (Page 500)

66-71
2. Configure the log host output channel
3. Enable/disable the log executed-commands
4. Display the log source
5. Display executed-commands state
1. Display and clear log buffer zone
Command Description
Admin Mode
show logging buffered [ level {critical |
warnings} | range <begin-index> <end-index>]
Show detailed log information in
the log buffer channel.
clear logging sdram Clear log buffer zone information.
2. Configure the log host output channel
Command Description
Global Mode
logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number> ] [level ]
no logging {> | <ipv6-addr>} [ facility
<local-number>]
Enable the output channel of the
log host. The “no” form of this
command will disable the output at
the output channel of the log host.
logging loghost sequence-number
no logging loghost sequence-number
Add the loghost sequence-number
for the log, the no command does
not include the loghost
sequence-number.
3. Enable/disable the log executed-commands
Command Description
Global mode
logging executed-commands {enable | disable}
Enable or disable the logging
executed-commands
4. Display the log source
Command Description
Admin and configuration mode