PLANET WGSW-52040 - Manual (Page 467)

59-38
Switch (Config-If-Ethernet1/1)#sflow rate output 10000
Switch (Config-If-Ethernet1/1)#sflow counter-interval 20
Switch (Config-If-Ethernet1/1)#exit
Switch (config)# interface ethernet1/2
Switch (Config-If-Ethernet1/2)#sflow rate input 20000
Switch (Config-If-Ethernet1/2)#sflow rate output 20000
Switch (Config-If-Ethernet1/2)#sflow counter-interval 40
59.4 sFlow Troubleshooting
In configuring and using sFlow, the sFlow server may fail to run properly due to physical connection failure,
wrong configuration, etc. The user should ensure the following:
 Ensure the physical connection is correct
 Guarantee the address of the sFlow analyzer configured under global or port mode is accessible.
 If traffic sampling is required, the sampling rate of the interface must be configured
 If statistic sampling is required, the statistic sampling interval of the interface must be configured
 If the examination remains unsolved, please contact with the technical service center of our
company.