PLANET WGSW-52040 - Manual (Page 325)

2. Configure MLD Snooping
Command Explanation
Global Mode
ipv6 mld snooping vlan
no ipv6 mld snooping vlan
Enable MLD Snooping on specific VLAN. The
“no” form of this command disables MLD
Snooping on specific VLAN.
ipv6 mld snooping vlan <vlan-id> limit
{group <g_limit> | source <s_limit>}
no ipv6 mld snooping vlan <vlan-id> limit
Configure the number of the groups in which
the MLD Snooping can join, and the
maximum number of sources in each group.
The “no” form of this command restores to
the default.
ipv6 mld snooping vlan <vlan-id>
l2-general-querier
no ipv6 mld snooping vlan <vlan-id>
l2-general-querier
Set the VLAN level 2 general querier, which
is recommended on each segment. The “no”
form of this command cancels the level 2
general querier configuration.
ipv6 mld snooping vlan
mrouter-port interface
no ipv6 mld snooping vlan
mrouter-port interface
Configure the static mrouter port in specific
vlan. The “no” form of this command cancels
the mrouter port configuration.
ipv6 mld snooping vlan <vlan-id>
mrouter-port learnpim6
no ipv6 mld snooping vlan <vlan-id>
mrouter-port learnpim6
Enable the function that the specified VLAN
learns mrouter-port (according to pimv6
packets), the no command will disable the
function.
ipv6 mld snooping vlan <vlan-id> mrpt
<value>
no ipv6 mld snooping vlan <vlan-id> mrpt
Configure the keep-alive time of the mrouter
port. The “no” form of this command restores
to the default.
ipv6 mld snooping vlan <vlan-id>
query-interval <value>
no ipv6 mld snooping vlan <vlan-id>
query-interval
Configure the query interval. The “no” form of
this command restores to the default.
ipv6 mld snooping vlan
immediate-leave
no ipv6 mld snooping vlan
immediate-leave
Configure immediate leave multicast group
function for the MLD Snooping of specific
VLAN. The “no” form of this command
cancels the immediate leave configuration.
ipv6 mld snooping vlan <vlan-id>
query-mrsp <value>
no ipv6 mld snooping vlan <vlan-id>
Configure the query maximum response
period. The “no” form of this command
restores to the default.
39-104