PLANET WGSW-52040 - Manual (Page 372)

dot1x accept-mac
<mac-address> [interface
<interface-name> ]
no dot1x accept-mac
<mac-address> [interface
<interface-name> ]
Adds 802.1x address filter table entry, the no command
deletes 802.1x filter address table entries.
dot1x eapor enable
no dot1x eapor enable
Enables the EAP relay authentication function in the
switch; the no command sets EAP local end
authentication.
4) Configure IPv6 passthrough function of the port
Command Explanation
Port Mode
dot1x ipv6 passthrough
no dot1x ipv6 passthrough
Enables IPv6 passthrough function of global mode on a
switch, only applicable when access control mode is
userbased; the no operation of this command will disable
the function.
3. Supplicant related property configuration
Command Explanation
Global Mode
dot1x max-req <count>
no dot1x max-req
Sets the number of EAP request/MD5 frame to be sent
before the switch re-initials authentication on no supplicant
response, the no command restores the default setting.
dot1x re-authentication
no dot1x re-authentication
Enables periodical supplicant authentication; the no
command disables this function.
dot1x timeout quiet-period
<seconds>
no dot1x timeout
quiet-period
Sets time to keep silent on port authentication failure; the
no command restores the default value.
dot1x timeout re-authperiod
<seconds>
no dot1x timeout
re-authperiod
Sets the supplicant re-authentication interval; the no
command restores the default setting.
42-151